Forum

Poll

Hi, I have been using MicaSense RedEdge MX Dual camera. I have been experiencing sunspots (brighter regions) in my orthomosaics processed using Agisoft Metashape. I have tried to manage the time accordingly but didn't get any improvement in my data.

Am I  missing any steps while processing?
0 (0%)
If its camera's issue then how to resolve?
1 (100%)

Total Members Voted: 1

Author Topic: Sunspots and data distortion  (Read 389 times)

narl

  • Newbie
  • *
  • Posts: 1
    • View Profile
Sunspots and data distortion
« on: June 03, 2024, 08:56:27 AM »
Anyone else facing this issue?

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14965
    • View Profile
Re: Sunspots and data distortion
« Reply #1 on: June 06, 2024, 04:53:34 PM »
Hello narl,

Do you use Reflectance Calibration procedure before building the orthomosaic? If so, then do you use panel, sun sensor or both?
If panel is used, make sure that the panel is properly masked for every source band.
Best regards,
Alexey Pasumansky,
Agisoft LLC