Forum

Author Topic: Manual from demotesting - Volumecalulation  (Read 5122 times)

spiker

  • Newbie
  • *
  • Posts: 32
    • View Profile
Manual from demotesting - Volumecalulation
« on: September 14, 2011, 10:18:34 PM »
First of all.
This is a very nice software.
I do ortomosaiks with an UAV covering pretty big spaces.
One of my services is to calculate volumes. Earlier i have been forced to hire an external contractor for that service. But with Photoscan i can do it faster, with equal resault and bigger gain in my wallet.

Is the demo limited to NOT calculate volumes?

I would like a short presentation via TeamViewer etc to see the workflow. Anybody?
johan@spiker.se

This is a buy for me :-)

Johan
Rotoview.se

Wishgranter

  • Hero Member
  • *****
  • Posts: 1202
    • View Profile
    • Museum of Historic Buildings
Re: Manual from demotesting - Volumecalulation
« Reply #1 on: September 15, 2011, 03:48:18 PM »
Have you the Profesional or Standard version ?
----------------
www.mhb.sk

spiker

  • Newbie
  • *
  • Posts: 32
    • View Profile
Re: Manual from demotesting - Volumecalulation
« Reply #2 on: September 16, 2011, 05:16:12 PM »
Thanx for quick reply.

I have downloaded the ProDemo.
Do i have to specify any groundGPSreference?
I can get GPS and altitude from my UAV for every picture taken. Would that help?

Johan

Wishgranter

  • Hero Member
  • *****
  • Posts: 1202
    • View Profile
    • Museum of Historic Buildings
Re: Manual from demotesting - Volumecalulation
« Reply #3 on: September 18, 2011, 05:22:42 PM »
yes, you need specify distances, without this sw cannot calculate volumes.....
----------------
www.mhb.sk

spiker

  • Newbie
  • *
  • Posts: 32
    • View Profile
Re: Manual from demotesting - Volumecalulation
« Reply #4 on: September 19, 2011, 11:18:20 AM »
Ok. I guess that the more accurate the references are the better volumeaccuracy.
Guess i can messure the distance between two lightpoles too and put them markers with PS to get the same resault.
Thanx for helping.

J

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 13150
    • View Profile
Re: Manual from demotesting - Volumecalulation
« Reply #5 on: September 19, 2011, 06:16:08 PM »
Hello spiker,

Please check the Volume Measurement Tutorial. I think it should help in your needs.

If you have any other questions or problems with your data you can contact us via support form.
Best regards,
Alexey Pasumansky,
Agisoft LLC