Forum

Author Topic: Pointcloud to Mesh in v1.0.2  (Read 3272 times)

gatsri

  • Jr. Member
  • **
  • Posts: 77
    • View Profile
Pointcloud to Mesh in v1.0.2
« on: February 21, 2014, 01:18:24 PM »
hello everyone!

I have a problem when i go from Pointcloud to Mesh:

Pointcloud looks good, but when i generate the Mesh (Highfield, High, from Dense Pointcloud) one building-wall is very bad...

As an attachment i have a picture, left the Mesh in Top view and Orthografic, right the same sector with the same view from the Pointcloud...

And a view from the side. (red line is plumb line)

Any idea whats wrong? never had this problem bevore v 1.0.2

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 13289
    • View Profile
Re: Pointcloud to Mesh in v1.0.2
« Reply #1 on: February 21, 2014, 01:30:50 PM »
Hello ristag,

I don't think we've changed anything in mesh generation in the version 1.0.2 compared to 1.0.1. Probably, red-colored side of the bounding box is not oriented correctly (should be almost parallel to XY plane)?
Best regards,
Alexey Pasumansky,
Agisoft LLC

gatsri

  • Jr. Member
  • **
  • Posts: 77
    • View Profile
Re: Pointcloud to Mesh in v1.0.2
« Reply #2 on: February 21, 2014, 01:53:21 PM »
Thanks Alexey for the fast answer.

It's not the the orientation of the bounding box. just check it, looks good...
I re-process the model, and give you a feedback...