Forum

Author Topic: photogrammetry with known camera positions  (Read 5629 times)

mayanic

  • Newbie
  • *
  • Posts: 6
    • View Profile
photogrammetry with known camera positions
« on: May 02, 2014, 10:50:24 AM »
hello,

just one question - does agisoft offer better results when the software knows the camera's position ...?!
is there a way to tell agisoft about the relative positions?

we have to minimize the space requirements for a 360 body setup :)

br mayanic

Tyler J

  • Newbie
  • *
  • Posts: 34
    • View Profile
Re: photogrammetry with known camera positions
« Reply #1 on: May 14, 2014, 01:18:55 PM »
From : TUTORIAL - Request

Quote from: Andrew
I personally don't import camera positions, it's just too easy for fixed cameras (and their lenses) to get gradually off their previously calibrated positions. Also, if you are using multicam rig with good lighting and some of your cams fail to align, it _usually_ means your photos are not sharp enough, or your cams are spread out too far etc. In case of really pale skin/featureless subject, you can go to 'Tools/Export/Export_Cameras', save your 'sphere' camera setup and then load it ('Tools Import\Import_Cameras' when you switch to your 'face' setup.

-Andrew