Features
Support
Community
Downloads
Buy
About
Forum
Home
Search
Login
Register
Agisoft Metashape
»
Agisoft Metashape
»
Camera Calibration
»
Distortion Coefficients
« previous
next »
Print
Pages: [
1
]
Author
Topic: Distortion Coefficients (Read 16105 times)
mwillis
Full Member
Posts: 140
Distortion Coefficients
«
on:
September 13, 2011, 05:02:15 PM »
Hi, can anyone tell me if the K1, K2, P1, and P2 coefficients are expressed in pixels, microns, or mm?
I am trying to convert from a known camera calibration to Agisoft's format.
Thank you,
Mark
Logged
Alexey Pasumansky
Agisoft Technical Support
Hero Member
Posts: 15276
Re: Distortion Coefficients
«
Reply #1 on:
September 13, 2011, 05:23:08 PM »
Hello Mark,
Distortion model used in Lens and PhotoScan is described in Lens Manual
http://downloads.agisoft.ru/lens/doc/en/lens.pdf
(last page).
Coefficients are expressed in inverse pixels.
Coefficients could be converted if the model of the original calibration you are using has the same transformation direction (from undistorted to distorted in PhotoScan/Lens). In other case conversion might be too complicated and even almost impossible.
You also can refer to the discussion where these parameters are mentioned -
http://www.agisoft.ru/forum/index.php?topic=132.msg594#msg594
Logged
Best regards,
Alexey Pasumansky,
Agisoft LLC
Print
Pages: [
1
]
« previous
next »
Agisoft Metashape
»
Agisoft Metashape
»
Camera Calibration
»
Distortion Coefficients
Features
Support
Community
Downloads
Buy
About
Features
Support
Community
Downloads
Buy
About
Metashape presentation
(PDF, 5 Mb)