Forum

Author Topic: Mesh, point...  (Read 3742 times)

Peter

  • Jr. Member
  • **
  • Posts: 71
    • View Profile
Mesh, point...
« on: June 16, 2014, 06:20:53 PM »
Any idea how i can get the mesh build not in the way shown in pictures?. I would like my mesh to go in an straight line and not upwards as that does not look that way in real life


admir

  • Jr. Member
  • **
  • Posts: 93
    • View Profile
Re: Mesh, point...
« Reply #1 on: June 16, 2014, 06:52:18 PM »
What interpolation are you using when building mesh? Its in Advanced submenu in Build Mesh. Try using disbled. Also, you are using masks ? Try masking unwanted areas. Third that might help you is to delete unwanted points from Dense point cloud.

HTH,

Admir

Peter

  • Jr. Member
  • **
  • Posts: 71
    • View Profile
Re: Mesh, point...
« Reply #2 on: June 16, 2014, 08:03:18 PM »
The problem for me is that agis dosent make the mesh based on the lower points that are visiblen and instead goes "high" and the i get the slope that are not supposed to be there.

I gues there that it makes the mesh to areas with high enogh point count or someting

Peter

  • Jr. Member
  • **
  • Posts: 71
    • View Profile
Re: Mesh, point...
« Reply #3 on: June 16, 2014, 10:09:28 PM »
I decided to manually mask out the water on the images rather than manually deleting points from dense point cloud before doing the mesh as i did in the images above

I think masking out the water is the better options

3DFranz

  • Newbie
  • *
  • Posts: 43
    • View Profile
Re: Mesh, point...
« Reply #4 on: June 17, 2014, 09:39:22 AM »
You should use Build Mesh - Arbitrary - Source Data : Dense Cloud-

Then you'll get a mesh that is simmilar to your dense cloud.

Surface type : Height field is only 2D + 1
Surface type: Arbitrary is 3D