Forum

Author Topic: Texture Export Issue  (Read 4775 times)

jknox

  • Newbie
  • *
  • Posts: 12
    • View Profile
Texture Export Issue
« on: October 13, 2011, 04:36:00 PM »
Having constructed a fairly decent topological model from 195 photos in a single build I have a problem with the texture export, (see attached).  There is a lot of blurring and detail missing that is present on the model in the viewport.  I have tried high quality and mosaic but to no avail.  Is this something that can be fixed?

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14813
    • View Profile
Re: Texture Export Issue
« Reply #1 on: October 13, 2011, 04:52:44 PM »
Hello jknox,

Could you please provide additional screenshots containing model view and chunk properties.
Best regards,
Alexey Pasumansky,
Agisoft LLC

jknox

  • Newbie
  • *
  • Posts: 12
    • View Profile
Re: Texture Export Issue
« Reply #2 on: October 13, 2011, 05:48:51 PM »
Hello,
Please find attached screenshot. 
Further info:  the build quality was set to 0 and then later decimated to 1000000.

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14813
    • View Profile
Re: Texture Export Issue
« Reply #3 on: October 13, 2011, 05:59:07 PM »
Hello jknox,

Could you please check you are using "Orthophoto" mapping mode at building texture stage. On the first screenshot it seems like texture was built using "Generic" mapping mode (in this mode the texture is cut into pieces) and it does not look like the model on the second one.
The blurred areas on the texture screenshot are just interpolated areas between texture pieces.
Best regards,
Alexey Pasumansky,
Agisoft LLC