Forum

Author Topic: no change in model display through all steps of workflow after photo alignment  (Read 4181 times)

Harilor

  • Newbie
  • *
  • Posts: 5
    • View Profile
New user here, so please be kind.
Using Win 7 Enterprise, 64 GB RAM, Nvidia Quadro k500.

After the initial install of APS, created several projects to "play" with prior to updating to version 1.0.4. Doing DEM/orthophoto projects. Was able to follow the workflow process with no problems, dispite having less than desirable photos to begin with. Didn't matter much, was just learning.

Patched to the newest version. Reprocessed some of the old projects from beginning to see improvements and learn new workflow.  Seemed to process through the workflow just fine.  Then yesterday, I started up a brand new project (mining depression). Aligned photos, adjusted region, created dense cloud.  However, now at this point, there seems to be no change in the density of the cloud. I then try to build the mesh.  The request processes, but no mesh appears on the model.  I then build texture, again, it processes but no texture appears on the model.  Confused, I go back to my other projects (3-4 other small projects) one of which was saved with a completed workflow. The completed one no longer had a mesh or texture. I try resetting the alignments and reworking the workflow, but now get same results, no dense cloud change, no mesh, and no texture applied, even though the processes seem to still run. I've created several brand new projects from scratch, using the same photos as the previous projects. Still get the same issue.   
I fully admit that I'm not using a good set of photos, but was getting the workflow process to operate fine (at a practice level) before. Not sure I can even pont my finger at the upgrade since it did work properly for a while after the patch. Wondering if this is just an odd bug and I need to reinstall.

Any assistance appreciated.

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14847
    • View Profile
Hello Harilor,

Probably, option "Switch to the model view by default" is turned off in the Preferences dialog (Advanced tab), so you need to swithc to different view modes manually from View menu or using corresponding buttons on the toolbar.
If the dense cloud and mesh are generated, the correposning info for the chunk will appear in the Workspace pane.
Best regards,
Alexey Pasumansky,
Agisoft LLC

Harilor

  • Newbie
  • *
  • Posts: 5
    • View Profile
Got it... TYVM.