Forum

Author Topic: path structure failiure in Linux  (Read 2171 times)

dcm39

  • Newbie
  • *
  • Posts: 34
    • View Profile
path structure failiure in Linux
« on: September 08, 2014, 01:19:31 PM »
Somewhere around the dense cloud reconstruction step, the path to the photos gets mixed up within the project.

When the photos were loaded into the project, they were navigated to via a soft link. I suspect this problem is due to a mistake in treating soft links in the linux version of the software, but it only became a problem later after resaving the project.

Question: If the paths to all the photos in the project have been corrupted in this way (4000 photos for this project), is there any way to relink them? I really don't want to spend several days rebuilding the dense point cloud.


Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 13297
    • View Profile
Re: path structure failiure in Linux
« Reply #1 on: September 08, 2014, 01:24:31 PM »
Hello dcm39,

Please try to use Change Path option from the Photos pane context menu.
Best regards,
Alexey Pasumansky,
Agisoft LLC

dcm39

  • Newbie
  • *
  • Posts: 34
    • View Profile
Re: path structure failiure in Linux
« Reply #2 on: September 08, 2014, 01:33:24 PM »
Thanks very much Alexey, that has resolved the problem.  It would be good if it didn't happen in the first place though!