Forum

Author Topic: Measurement in VIEWER  (Read 6960 times)

Darko

  • Full Member
  • ***
  • Posts: 121
    • View Profile
    • CADCOM
Re: Measurement in VIEWER
« Reply #15 on: April 07, 2021, 10:35:13 AM »
 8) Thanks Aleksey,
You've done some serious job with the Viewer. Separate installation is here as well. You've been listening to us, great.
Can you provide some manual for it, please. I have tried to vectorize couple of lines but don't know how to rotate the view while in the Draw mode. Also, as I see my models are below the ground level of the base map, how can I correct it? I might know the reason since my geoid datum is about 42 meters below the ellipsoid but how to correct it? There is also the question of the 3D stereo view? In this version I cannot use the Vertical split and set my monitor/TV to 3D side by side view as I used earlier and it was working fine with my polarized glasses. I used to make presentations with it for the audience since I have 12 pairs of those glasses.
Thumbs UP.. Thank's again on your effort.