The scale I set in PhotoScan does not seem to carry over when I export models to third party software (Meshlab or Geomagic).
In PhotoScan, I set scale on a model by placing two points. I know the distance between these points. I highlight the two points in the Ground Control panel, then select "Create Scale Bar." I enter the distance between the two points. Then I export the model in ply.
The scale is not retained in Geomagic or Meshlab. Is there a step I am missing?
A separate question: in the Ground Control settings, I am able to change the measurement accuracy settings. For example, the default scale bar accuracy is 0.001 m. Do I get better scale bar accuracy if I change this setting to 0.000001?