Features
Support
Community
Downloads
Buy
About
Forum
Home
Search
Login
Register
Agisoft Metashape
»
Agisoft Metashape
»
General
»
Dense point cloud - processing time
« previous
next »
Print
Pages: [
1
]
Author
Topic: Dense point cloud - processing time (Read 2870 times)
janoz
Newbie
Posts: 8
Dense point cloud - processing time
«
on:
January 07, 2015, 08:13:19 PM »
I have an experience : after optimalization procedure according to GCPs when i start to process dense point cloud once again - the procsseing time is usually 3 or 4 times higher in comparison to the first dense pointcloud generation. Quality parametres remain the same. The situation is accompanied by the log message. "skipping pair: unable to estimate disparity range" which i wasnt aware of before. The situation is the same as tracted in the post:
http://www.agisoft.com/forum/index.php?topic=2147.0
, but without any further explanation or answers.
I have to stress that i am currently still using 1.0.0 vesrion bacause i am in the middle of the project and dont wanna jump to higher version until i finish it.
«
Last Edit: January 07, 2015, 11:35:22 PM by janoz
»
Logged
Verified Maidens
Alexey Pasumansky
Agisoft Technical Support
Hero Member
Posts: 15133
Re: Dense point cloud - processing time
«
Reply #1 on:
January 08, 2015, 10:38:36 AM »
Hello janoz,
If you have CL_MEM_OBJECT_ALLOCATION_FAILURE errors in the Console pane, then roll-back nVidia drivers to 337.23 or older, since newer version drivers have compatibility issues with PhotoScan 1.0.
Logged
Best regards,
Alexey Pasumansky,
Agisoft LLC
Print
Pages: [
1
]
« previous
next »
Agisoft Metashape
»
Agisoft Metashape
»
General
»
Dense point cloud - processing time
Features
Support
Community
Downloads
Buy
About
Features
Support
Community
Downloads
Buy
About
Metashape presentation
(PDF, 5 Mb)