Features
Support
Community
Downloads
Buy
About
Forum
Home
Search
Login
Register
Agisoft Metashape
»
Agisoft Metashape
»
Feature Requests
»
Origin alignment by point selection
« previous
next »
Print
Pages: [
1
]
Author
Topic: Origin alignment by point selection (Read 6848 times)
Drakhain
Newbie
Posts: 20
Origin alignment by point selection
«
on:
January 31, 2015, 04:50:21 AM »
It would be very helpfull and more precise if photoscan allowed us to orient the model by aligning the origin to a plane made by averaging a set of selected points positions.
Rotate/translate region/model workflow is quite tedious and hard depending on hardware and model complexity.
Logged
dcm39
Newbie
Posts: 34
Re: Origin alignment by point selection
«
Reply #1 on:
February 17, 2015, 06:02:28 PM »
Definitely second this one.
Logged
dcm39
Newbie
Posts: 34
Re: Origin alignment by point selection
«
Reply #2 on:
February 17, 2015, 06:04:45 PM »
And similarly/equivalently, it would be really useful to be able to specify the orientation of a scale bar (azimuth, elevation and xyz location of one end) to completely specify the orientation of the model.
Logged
bigben
Sr. Member
Posts: 406
Re: Origin alignment by point selection
«
Reply #3 on:
February 25, 2015, 01:20:22 AM »
Wouldn't specifying local coordinates for the points of the scale bar do this?
Logged
dcm39
Newbie
Posts: 34
Re: Origin alignment by point selection
«
Reply #4 on:
February 26, 2015, 03:20:03 PM »
I guess so - one could work out relative coordinates based on the orientation.
I was really going on the fact that it is the elevation azimuth and length that are the easy quantities to measure in the field.
Logged
Print
Pages: [
1
]
« previous
next »
Agisoft Metashape
»
Agisoft Metashape
»
Feature Requests
»
Origin alignment by point selection
Features
Support
Community
Downloads
Buy
About
Features
Support
Community
Downloads
Buy
About
Metashape presentation
(PDF, 5 Mb)