Scale bar based optimization

[Ant]

Hi there,
I've been running the scale bar based optimization and it gives me an higher marker error (pix). Is that normal?
Regards,
Ant

[Ant]

Hi there,

Just two more questions about the scale bar based optimization:

- Should we leave the default values in the reference settings? Or should we modify them according to the values that we've got after the aligning step?

- Should we re-run the aligning step after doing the scale bar based optimization?

For info, I use a single ruler that is accurate to the millimetres to create one scale bar.

I hope someone will be able to assist me with this.

Cheers,
Ant

[MeHoo]

I've looked into the scale bars, but I'm still clueless.. care to share your workflow?