Features
Support
Community
Downloads
Buy
About
Forum
Home
Search
Login
Register
Agisoft Metashape
»
Agisoft Metashape
»
Bug Reports
»
Error: bad locale name (not sure if this is a bug)
« previous
next »
Print
Pages: [
1
]
Author
Topic: Error: bad locale name (not sure if this is a bug) (Read 3233 times)
wojtek
Sr. Member
Posts: 284
Error: bad locale name (not sure if this is a bug)
«
on:
December 25, 2021, 03:55:04 PM »
I've gotten this error a couple of times when saving in the latest 1.8.0 build. Can you guys elaborate a bit on what this is about?
Logged
Alexey Pasumansky
Agisoft Technical Support
Hero Member
Posts: 15168
Re: Error: bad locale name (not sure if this is a bug)
«
Reply #1 on:
December 25, 2021, 09:08:04 PM »
Hello wojtek,
please check the newly published 1.8.0 pre-release (build 13736), do you still observe locale name issue?
Logged
Best regards,
Alexey Pasumansky,
Agisoft LLC
wojtek
Sr. Member
Posts: 284
Re: Error: bad locale name (not sure if this is a bug)
«
Reply #2 on:
December 26, 2021, 11:24:37 AM »
Installed the new build and tested on the same project, saved properly this time.
Logged
Print
Pages: [
1
]
« previous
next »
Agisoft Metashape
»
Agisoft Metashape
»
Bug Reports
»
Error: bad locale name (not sure if this is a bug)
Features
Support
Community
Downloads
Buy
About
Features
Support
Community
Downloads
Buy
About
Metashape presentation
(PDF, 5 Mb)