Exported One-Band Orthophotos

[Ashura]

Hello everyone!

Basically I used a 5-band sensor to acquire UAV imagery. The raw data comes out with each band as a separate image file. Since I can't mass stack these frame by frame (slight offset in bands) I decided to process 5 orthophotos and align them afterwards to deal with offset. (Incase you are wondering I used the micasense multispectral camera).

So, I did just that... however the single band imagery when mosaicked and exported as an ortho comes out as two band (gray and alpha).

Is there a way to make sure it stays one band for export?

Thanks all so so much

[Alexey Pasumansky]

Hello Ashura,

PhotoScan saves alpha-channel since it defines the borders of the exported area.