Is it possible in the next release, to get an option to "Decimate Mesh" with iterations?
We have made tests with a mesh of 65 mio faces (see attached image 1) and reduce it to 6500 faces (testing for best results with small number of faces).
What we get in the result is, when you decimate the mesh only in one step from 65mio to 6500 it is much more inaccurate (more sloping corners, inaccurate breakelines -> see attached image 2)
We then decimated the mesh with more steps like 65mio -> 32mio -> 16mio -> 8mio...and so on at the end to 6500 (13 steps of decimation). It gets a way better result/ accuracy in corners/ breakelines (see this in attached image 3).
We may dont have to get to 6500 faces, buts it's for now the best test of model accuracy.
Thanks at all for a superb piece of software.
Regards,
Ben.