Forum

Author Topic: Problem with: Print Marker  (Read 2789 times)

mwittnebel

  • Jr. Member
  • **
  • Posts: 56
    • View Profile
Problem with: Print Marker
« on: October 23, 2015, 04:56:57 PM »
Hallo,

We want to try the auto detection function of markers in Agisoft Photoscan.

I created with Agisoft some markers with different center point radius’s (tools > markers > print markers)

This is working well if the center point radius is less then 30mm. If the center point radius is greater then 30mm, then the marker is not fitting on the created pages (1 marker per page). Is it possible to change the exporting page size of the pages from A4 to A3 or even bigger ?

Our a ground resolution is normally around 5cm per pixel.

Regards Marcus

Wishgranter

  • Hero Member
  • *****
  • Posts: 1202
    • View Profile
    • Museum of Historic Buildings
Re: Problem with: Print Marker
« Reply #1 on: October 23, 2015, 06:48:58 PM »
easy solution  take the PDF to the print shop and they can print in "any" size. as when printing can set it to desired size....
----------------
www.mhb.sk

mwittnebel

  • Jr. Member
  • **
  • Posts: 56
    • View Profile
Re: Problem with: Print Marker
« Reply #2 on: October 26, 2015, 02:51:54 PM »
This sounds logical ;)