Forum

Author Topic: different behaviour of the build dense cloud process  (Read 2193 times)

virtek

  • Newbie
  • *
  • Posts: 1
    • View Profile
different behaviour of the build dense cloud process
« on: October 29, 2015, 01:48:11 AM »
hi,

in PhotoScan 1.2.0 build 2172 after aligned (generic or referenced it doesn't matter, both checked) something strange is going one in dense cloud process.
Maybe this is cause by two sets of photos from different heights (30 AGL and 140 AGL) but if it's aligned and tie points looks good, the dense point cloud doesn't.

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14107
    • View Profile
Re: different behaviour of the build dense cloud process
« Reply #1 on: October 29, 2015, 08:16:44 AM »
Hello virtek,

It seems to be an alignment issue, not a problem of the dense cloud. The subsets of photos taken from the different altitude were not correctly aligned with each other.
Best regards,
Alexey Pasumansky,
Agisoft LLC