Features
Support
Community
Downloads
Buy
About
Forum
Home
Search
Login
Register
Agisoft Metashape
»
Agisoft Metashape
»
Bug Reports
»
DEM from Mesh not working
« previous
next »
Print
Pages: [
1
]
Author
Topic: DEM from Mesh not working (Read 6412 times)
mwillis
Full Member
Posts: 140
DEM from Mesh not working
«
on:
December 29, 2015, 12:58:36 AM »
Hi, I noticed a bug in the latest version of Photoscan. If you trim a mesh in Photoscan and then export as a DEM, the trimmed areas are still present but exported as flat areas.
«
Last Edit: December 29, 2015, 01:32:21 AM by mwillis
»
Logged
Alexey Pasumansky
Agisoft Technical Support
Hero Member
Posts: 15067
Re: DEM from Mesh not working
«
Reply #1 on:
December 29, 2015, 12:25:01 PM »
Hello Mark,
If you are using enabled interpolation, then DEM will be interpolated in the areas that are visible from at least one camera inside bounding box.
Logged
Best regards,
Alexey Pasumansky,
Agisoft LLC
frank.stremke
Full Member
Posts: 206
Re: DEM from Mesh not working
«
Reply #2 on:
January 07, 2016, 10:24:08 PM »
same problem here
iam not abele to deactivate interpolation thats the bug i think
enabled is the only option in the menue
absolutly annoying thing!
frank
Logged
Alexey Pasumansky
Agisoft Technical Support
Hero Member
Posts: 15067
Re: DEM from Mesh not working
«
Reply #3 on:
January 08, 2016, 06:02:23 PM »
Hello Frank,
Disabled interpolation option for DEM based on Mesh generation will be available inthe next version update.
Logged
Best regards,
Alexey Pasumansky,
Agisoft LLC
frank.stremke
Full Member
Posts: 206
Re: DEM from Mesh not working
«
Reply #4 on:
January 08, 2016, 08:12:29 PM »
thanks
this is very much needed since i work a lot with the mesh on my old projects and not no much the dense point cloud
frank
Logged
Print
Pages: [
1
]
« previous
next »
Agisoft Metashape
»
Agisoft Metashape
»
Bug Reports
»
DEM from Mesh not working
Features
Support
Community
Downloads
Buy
About
Features
Support
Community
Downloads
Buy
About
Metashape presentation
(PDF, 5 Mb)