Features
Support
Community
Downloads
Buy
About
Forum
Home
Search
Login
Register
Agisoft Metashape
»
Agisoft Metashape
»
General
»
Detecting non coded markers
« previous
next »
Print
Pages: [
1
]
Author
Topic: Detecting non coded markers (Read 6787 times)
vitoseto
Newbie
Posts: 2
Detecting non coded markers
«
on:
March 07, 2016, 09:43:51 PM »
Hello everybody,
I would like to ask you, does someone have an idea if it is possible to detect non coded markers like this? I have been working on my diploma thesis recently, that is based on accourancy test of 300 control points. Thank you for all your assistance.
Logged
bigben
Sr. Member
Posts: 406
Re: Detecting non coded markers
«
Reply #1 on:
March 09, 2016, 03:39:10 PM »
After alignment
Tools > Markers > Detect Markers.
Marker type: Cross (non coded)
Logged
vitoseto
Newbie
Posts: 2
Re: Detecting non coded markers
«
Reply #2 on:
March 09, 2016, 08:35:31 PM »
Thank you for the answer, I tried that steps with no results before. I decided that better way is load marker coordinates and system will show estimated location that is almost as exact as center of marker.
Logged
bigben
Sr. Member
Posts: 406
Re: Detecting non coded markers
«
Reply #3 on:
March 10, 2016, 04:41:27 AM »
You can increase the sensitivity if the markers are small on the image. Depending on your subject though, you may get some false markers detected as you get higher eg. branches in trees with white sky behind.
Logged
Print
Pages: [
1
]
« previous
next »
Agisoft Metashape
»
Agisoft Metashape
»
General
»
Detecting non coded markers
Features
Support
Community
Downloads
Buy
About
Features
Support
Community
Downloads
Buy
About
Metashape presentation
(PDF, 5 Mb)