Forum

Author Topic: Sketchfab Uploader reporting error  (Read 6302 times)

Hamish

  • Newbie
  • *
  • Posts: 22
    • View Profile
Sketchfab Uploader reporting error
« on: April 02, 2016, 11:08:44 PM »
Only had this issue with version 1.2.4 - model uploads, then goes onto processing, then at end of processing normally PS displays the url of the model on sketchfab but instead there is the following error message:

Can't upload model: Unknown error (200)
{"result": true, "sucess":true}

Photoscan Standard 1.2.4 , winX64

But model has successfully uploaded to sketchfab - so there doesn't appear to be a real problem.

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14927
    • View Profile
Re: Sketchfab Uploader reporting error
« Reply #1 on: April 04, 2016, 09:48:57 PM »
Hello Hamish,

Thank you for reporting, we'll fix that.
Best regards,
Alexey Pasumansky,
Agisoft LLC

James

  • Hero Member
  • *****
  • Posts: 750
    • View Profile
Re: Sketchfab Uploader reporting error
« Reply #2 on: April 05, 2016, 11:10:59 PM »
May or may not be related, but i am getting the same error, yet viewing the model in sketchfab i can see that it does not appear to have uploaded properly.

There are clear gaps, probably coinciding with 'seams' between texture maps in sketchfab that are not visible in photoscan.

i used generic 4x4096 mapping for this one.

Problem occurs for mesh at both ~1m and 250k faces.

It seems that the mesh is split into sections that have been physically displaced from each other, rather than just a transparent slither at the seam.
« Last Edit: April 05, 2016, 11:13:19 PM by James »

James

  • Hero Member
  • *****
  • Posts: 750
    • View Profile
Re: Sketchfab Uploader reporting error
« Reply #3 on: April 06, 2016, 12:20:50 PM »
Uploaded to sketchfab using the sketchfab uploader on their website and the problem persists.

No problem viewing the textured mesh in blender.

Uploaded to sketchfab from blender and same problem.

Seems to be a sketchfab problem or i'm missing something!

Eventually uploaded from photoscan with a single 1x8192 texture map and it's ok.

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14927
    • View Profile
Re: Sketchfab Uploader reporting error
« Reply #4 on: April 06, 2016, 02:12:02 PM »
Hello James,

Thanks for reporting. Unfortunately, I wasn't able to reproduce the issue with the multi-page texture atlases - everything is displayed correctly on Sketchfab. Doesn't it happen on any random project or only related to a specific one?
Best regards,
Alexey Pasumansky,
Agisoft LLC

James

  • Hero Member
  • *****
  • Posts: 750
    • View Profile
Re: Sketchfab Uploader reporting error
« Reply #5 on: April 06, 2016, 02:52:36 PM »
I can't seem to reproduce it on a different project i just tried, and as far as i can remember haven't seen it before either.