RMS Reprojection Error vs. Max reprojection Error

[holgar]

Hello, I made scan with 577 Cameras. I did as always some filtering and applied a optimizes Cameras.
Now I have a much less RMS reprojection Error. But the Max reprojection Error got worse.
I wonder what is the reason here. Should I prefer the optimized version with less RMS reprojection or should I keep the unoptimized version with less Max Reprojection Error?

[stihl]

I'd definitly go for the project with the lower RMS error.

The max error refers to outlier tie-points that are most likely irrelevant.

Got a screenshot of your tie-points?

[holgar]

I'd definitly go for the project with the lower RMS error.

The max error refers to outlier tie-points that are most likely irrelevant.

Got a screenshot of your tie-points?

Ok Thanks. I will stick to the optimized version than. Here is a screencap of the Tie Pointcloud. Its pretty dense still after filtering with 900k points. I guess that should be good ;-)

[stihl]

That looks pretty good. Very good overlap because I see hardly any missing regions.

You could try and manually delete some of the floating outlier tie-points to clean it up further, but it's not explicitly necessary .

[holgar]

That looks pretty good. Very good overlap because I see hardly any missing regions.

You could try and manually delete some of the floating outlier tie-points to clean it up further, but it's not explicitly necessary .

Yes, I have already deleted some floating points. The only problem area is the hands as they are reflective.