Forum

Author Topic: Add/remove photos after GCP points all done?  (Read 2417 times)

rossnixon

  • Full Member
  • ***
  • Posts: 100
    • View Profile
Add/remove photos after GCP points all done?
« on: July 21, 2016, 01:28:35 AM »
I have 38 aerial photos in my project.
I have located and marked GCPs on all the photos.

I should have checked the photo quality earlier, and now want to remove 4 photos and replace them with some spare photos. Can I do this without re-observing all my GSPs?

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 15139
    • View Profile
Re: Add/remove photos after GCP points all done?
« Reply #1 on: July 21, 2016, 01:43:54 PM »
Hello rossnixon,

You can remove some photos from the project and add new ones, then you can specify the projections of existing markers on those photos using Place Marker option in the Photo view mode.

However, please note that photos added to already aligned image set wouldn't contain any tie points, so you'll need to run the Align Photos operation for the complete set again.
Best regards,
Alexey Pasumansky,
Agisoft LLC