Forum

Author Topic: outer boundary applied to exports  (Read 1898 times)

JMR

  • Sr. Member
  • ****
  • Posts: 446
    • View Profile
outer boundary applied to exports
« on: August 26, 2016, 02:52:18 PM »
As far as I know, boundary limits are just applied during ortho and DEM export. I'd like it was possible to apply it also to void mesh and dense cloud outside during export.
This would be very convenient for corridor mapping.
By now my only workaroung consist on creating a low poly mesh, crop out selection made by hand laso (one of my least favourite tools currently), then use mesh for masking prior to run dense cloud cleation. it mostly works, but the boundaries look like an ugly saw.
Regards!