Forum

Author Topic: Export Region (specify four dimensions)  (Read 3964 times)

IanManning

  • Newbie
  • *
  • Posts: 16
    • View Profile
Export Region (specify four dimensions)
« on: September 01, 2016, 09:11:50 PM »
I'm looking to specific regions of products from PhotoScan. I'm building models of forested areas and am only interested in a subset of the model. Rather than build my products and edit extents in GIS software, I was wondering whether it is currently possible to functionally export an extent of the model as specified by four coordinate pairs rather than two?

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 15146
    • View Profile
Re: Export Region (specify four dimensions)
« Reply #1 on: September 02, 2016, 01:10:06 PM »
Hello IanManning,

If you are speaking about limiting the export area for the orthomosaic or DEM, then you can draw shape in the Ortho view or import the shapes from the external file (KML, SHP, DXF formats are supported) and set up Outer Boundary type for the shape. Export Orthomosaic/DEM operations will automatically save only area inside the boundary.
Best regards,
Alexey Pasumansky,
Agisoft LLC