Forum

Author Topic: texture count option doesn't work  (Read 3434 times)

Elki

  • Newbie
  • *
  • Posts: 11
    • View Profile
texture count option doesn't work
« on: December 19, 2016, 12:59:23 PM »
Hallo!

I'm trying to generate more then one texture file using the option texture count, but the option is not enabled. Usually it works...
Any suggestion? Do you know if I can split it later in other softwares like 3DS o ZBrush?

Thank you very much!

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14813
    • View Profile
Re: texture count option doesn't work
« Reply #1 on: December 19, 2016, 01:02:01 PM »
Hello Elki,

Multi-page texture atlas is supported for Generic mapping mode only (and for custom UV atlas, if Keep UV option is used).
Best regards,
Alexey Pasumansky,
Agisoft LLC

Elki

  • Newbie
  • *
  • Posts: 11
    • View Profile
Re: texture count option doesn't work
« Reply #2 on: December 19, 2016, 01:11:16 PM »
Thank you Alexey!

In generic it works, as you say, but not in keep UV.

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14813
    • View Profile
Re: texture count option doesn't work
« Reply #3 on: December 19, 2016, 01:18:11 PM »
Hello Elki,

For Keep UV is should work if the imported model already has multi-page texture parametrization (and the texture hasn't been rebuilt in PhotoScan after that using any other mapping mode).
Best regards,
Alexey Pasumansky,
Agisoft LLC

Elki

  • Newbie
  • *
  • Posts: 11
    • View Profile
Re: texture count option doesn't work
« Reply #4 on: December 19, 2016, 01:46:40 PM »
Clear! Thank you again!