Features
Support
Community
Downloads
Buy
About
Forum
Home
Search
Login
Register
Agisoft Metashape
»
Agisoft Metashape
»
General
»
GoPro FishEye
« previous
next »
Print
Pages: [
1
]
Author
Topic: GoPro FishEye (Read 2570 times)
jazzyj
Jr. Member
Posts: 87
GoPro FishEye
«
on:
February 16, 2019, 05:11:09 AM »
In Tools -> Camera Calibration I can see Photoscan correctly identified the camera as a GoPro Hero 4 Silver. However it looks to me on that on the photos used on the outer edges of my orthomosaic still have a warmed fisheye look. The interior of the mosaic has no distortion due to the overlap. Does the camera calibration not remove the fisheye from the photos? Would I therefore get better results if I lens corrected the GoPro photos before bringing them into Photoscan?
Logged
Alexey Pasumansky
Agisoft Technical Support
Hero Member
Posts: 14847
Re: GoPro FishEye
«
Reply #1 on:
February 16, 2019, 12:53:10 PM »
Hello jazzyj,
If the lens used causes obvious Fisheye distortions, then it is recommended to switch the camera type to fisheye in the Camera Calibration dialog (from default Frame value) prior to the image processing.
Logged
Best regards,
Alexey Pasumansky,
Agisoft LLC
Print
Pages: [
1
]
« previous
next »
Agisoft Metashape
»
Agisoft Metashape
»
General
»
GoPro FishEye
Features
Support
Community
Downloads
Buy
About
Features
Support
Community
Downloads
Buy
About
Metashape presentation
(PDF, 5 Mb)