Forum

Author Topic: Merging Chunks  (Read 2984 times)

spiegel

  • Newbie
  • *
  • Posts: 30
    • View Profile
Merging Chunks
« on: February 16, 2017, 03:35:04 PM »
I expect a bigger project in the near future, so I started to work with chunks.

For testing I took a (quite small) set of fotos and first made a "normal" modell (just one chunk), which was ok.
Then I took 3 parts of the same foto-set and made 3 chunk and modells.
The chunks "overlapped", means, I used some equal fotos from chunk 1 in chunk 2 and from chunk 2 in chunk 3.

All chunks were calculated in the same way (medium allign and medium dense cloud).
The results of the single chunks were ok.
But after merging the  3 chunks to one chunk, there are ghosts and blurry parts, see attachment.

Where is my mistake ?

mwittnebel

  • Jr. Member
  • **
  • Posts: 56
    • View Profile
Re: Merging Chunks
« Reply #1 on: February 16, 2017, 06:20:54 PM »
What align Chunk Method did you use ? (Point/Marker/Camera)

spiegel

  • Newbie
  • *
  • Posts: 30
    • View Profile
Re: Merging Chunks
« Reply #2 on: February 16, 2017, 06:39:19 PM »
I used

workflow --> Merge chunks --> Merge dense clouds

spiegel

  • Newbie
  • *
  • Posts: 30
    • View Profile
Re: Merging Chunks
« Reply #3 on: February 20, 2017, 11:44:11 AM »
Solved the problem, I think.

My mistake was testing with a too small set of photos.
I tried it again with two big chunks, works correctly.

barrubba

  • Jr. Member
  • **
  • Posts: 57
    • View Profile
Re: Merging Chunks
« Reply #4 on: May 03, 2017, 10:04:23 PM »
why even after merge dense cloud it showed yet 2 separate chunks?