Forum

Author Topic: Orthomosaic // discrepancy between markers in PointCloud  (Read 1881 times)

toxicmag

  • Jr. Member
  • **
  • Posts: 88
    • View Profile
Orthomosaic // discrepancy between markers in PointCloud
« on: March 16, 2017, 12:13:57 PM »
Dear users,

i'm building an orthophoto of a buidling facade and i'm using a local coordinate system for that.
Everything is fine, but when it comes to buidling the orthomosaic (using the specific projection pane for each side of the building) there is a shift of all the marker positions.

It's fine in pointcloud view and also mesh, so it must be some mistake in projection.

Type is "planar" and surface is mesh. Blending mode Mosaic.


Any ideas?   :/

Thanks

Alex
#multirotor #VTOL #Trinity #Quantum-Systems #a6000 #a7R #RedEdge #ALTUM #RX1II

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14813
    • View Profile
Re: Orthomosaic // discrepancy between markers in PointCloud
« Reply #1 on: March 16, 2017, 12:31:02 PM »
Hello Alex,

Can you check if the same issue is observed, if you build Orthomosaic for the same project with the same settings in the version 1.3.0?
Best regards,
Alexey Pasumansky,
Agisoft LLC

toxicmag

  • Jr. Member
  • **
  • Posts: 88
    • View Profile
Re: Orthomosaic // discrepancy between markers in PointCloud
« Reply #2 on: March 16, 2017, 05:31:41 PM »
Hello Alexey,

thanks for the quick reply. I really appreciate because it's a "hot" client project and until i came to Orthoprojection one week of processing work is already put into it...

There seems to be no update available for the 64bit version. Should i do it manually?


Greetings

Alex
#multirotor #VTOL #Trinity #Quantum-Systems #a6000 #a7R #RedEdge #ALTUM #RX1II

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14813
    • View Profile
Re: Orthomosaic // discrepancy between markers in PointCloud
« Reply #3 on: March 16, 2017, 05:45:45 PM »
Hello Alex,

Version 1.3.0 can be generated from the following page:
http://www.agisoft.com/downloads/installer/

So I can suggest to install it and generate Orthomosaic there.
Best regards,
Alexey Pasumansky,
Agisoft LLC

toxicmag

  • Jr. Member
  • **
  • Posts: 88
    • View Profile
Re: Orthomosaic // discrepancy between markers in PointCloud
« Reply #4 on: March 16, 2017, 06:32:10 PM »
solved
#multirotor #VTOL #Trinity #Quantum-Systems #a6000 #a7R #RedEdge #ALTUM #RX1II