Author Topic: Version 1.3.0, build 3772 (64 bit): No option for markers overall accuracy  (Read 2927 times)


  • Newbie
  • *
  • Posts: 9
    • View Profile
Hello Everyone!

Just switched to 1.3.0, build 3772. When importing  marker coordinates, in 1.2, there was an option to import the marker overall accuracy. This option is gone in 1.3: by ticking "Accuracy" one needs to enter the accuracy in x, y, and z directions, see attached figure. However, the marker pane only shows overall accuracy, and no x, y, z accuracy value is imported even if selected.


Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14758
    • View Profile
Hello Ft,

If you right-click on the column label in the bottom preview frame of the Import CSV dialog, you can choose "All" for the Location Accuracy. It would mean that values from the same value will be assigned as overall accuracy for the marker/camera without splitting.
Best regards,
Alexey Pasumansky,
Agisoft LLC