Forum

Author Topic: Merging Chunks  (Read 1438 times)

FrostBite

  • Newbie
  • *
  • Posts: 26
    • View Profile
Merging Chunks
« on: April 30, 2017, 03:49:26 AM »
 I am having problems with merging chunks.

I have a total of approx. 2000 photos. I broke them down into 4 chunks (so 500 photos each). Everything worked properly, the only problem is that when I tried merging two of the chunks together, one was higher (elevation-wise) than the other.

How do I remedy this? Should I simply merge all chunks together at once? Or one at a time?

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 13913
    • View Profile
Re: Merging Chunks
« Reply #1 on: April 30, 2017, 09:35:49 AM »
Hello FrostBite,

Which information you are using for georeferencing of the chunks and how big is the elevation difference?

Best regards,
Alexey Pasumansky,
Agisoft LLC

FrostBite

  • Newbie
  • *
  • Posts: 26
    • View Profile
Re: Merging Chunks
« Reply #2 on: April 30, 2017, 01:08:17 PM »
 Each photo has fairly accurate co-ordinates in the meta-data. And the elevation difference is about 40-60 meters.

I have had this problem before with merging chunks. And I did figure it out. It was a simple solution but I haven't been able to replicate it.