Author Topic: Can't Build Pyramid Data message  (Read 3629 times)


  • Newbie
  • *
  • Posts: 20
    • View Profile
Can't Build Pyramid Data message
« on: July 05, 2017, 12:52:24 AM »
I am working on a large project of 3,700 images. I have very accurate camera GPS positions along with some ground control.

The images aligned fine using the highest accuracy setting. I then built a mesh and dense cloud with no problem.

When I went to the "build orthomosaic" step, the computer would work for 2 days, the give the message "can't build pyramid data".

I am running out of time to deliver this project and am looking for any suggestions on how to proceed at this point.



Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14968
    • View Profile
Re: Can't Build Pyramid Data message
« Reply #1 on: July 05, 2017, 12:16:02 PM »
Hello Dave,

Usually such message is indicating either the lack of the disk space on the drive where the project folder is stored or to the connection issues, if the images/project are stored on network or external drive.
Best regards,
Alexey Pasumansky,
Agisoft LLC