Forum

Author Topic: Aligning chunks in steps?  (Read 3099 times)

patcarbon

  • Newbie
  • *
  • Posts: 22
    • View Profile
Aligning chunks in steps?
« on: October 16, 2012, 04:22:08 PM »
I'm processing a 2000 image project.  The surface is quite self-similar and aligning the entire project in 1 chunk was a disaster (see below). So I'm having to use several chunks.  I'm now on 7 chunks (which correspond to 7 UAV flights) and I'd like to end up with 1-2 chunks before I optimise.

Is it possible to use markers to performa an initial chunk alignment and then have a point-cloud match to reffine this alignement?  Does the 'points' align option just delete any previous alignment?

thanks
Patrice   

Wishgranter

  • Hero Member
  • *****
  • Posts: 1202
    • View Profile
    • Museum of Historic Buildings
Re: Aligning chunks in steps?
« Reply #1 on: October 16, 2012, 07:41:52 PM »
Yes, is a low overlap, next time use higher = 60 - 80 % afther that can disable images from there..

And is possible set custom POINTS, without precise data, then try ALIGN again.....

----------------
www.mhb.sk