Features
Support
Community
Downloads
Buy
About
Forum
Home
Search
Login
Register
Agisoft Metashape
»
Agisoft Metashape
»
General
»
Aligning chunks in steps?
« previous
next »
Print
Pages: [
1
]
Author
Topic: Aligning chunks in steps? (Read 3347 times)
patcarbon
Newbie
Posts: 22
Aligning chunks in steps?
«
on:
October 16, 2012, 04:22:08 PM »
I'm processing a 2000 image project. The surface is quite self-similar and aligning the entire project in 1 chunk was a disaster (see below). So I'm having to use several chunks. I'm now on 7 chunks (which correspond to 7 UAV flights) and I'd like to end up with 1-2 chunks before I optimise.
Is it possible to use markers to performa an initial chunk alignment and then have a point-cloud match to reffine this alignement? Does the 'points' align option just delete any previous alignment?
thanks
Patrice
Logged
Wishgranter
Hero Member
Posts: 1202
Re: Aligning chunks in steps?
«
Reply #1 on:
October 16, 2012, 07:41:52 PM »
Yes, is a low overlap, next time use higher = 60 - 80 % afther that can disable images from there..
And is possible set custom POINTS, without precise data, then try ALIGN again.....
Logged
----------------
www.mhb.sk
Print
Pages: [
1
]
« previous
next »
Agisoft Metashape
»
Agisoft Metashape
»
General
»
Aligning chunks in steps?
Features
Support
Community
Downloads
Buy
About
Features
Support
Community
Downloads
Buy
About
Metashape presentation
(PDF, 5 Mb)