Chunks again

[End-User]

Hi,

Is it possible to add a function to switch on and off  certain chunks or groups of chunks? It will be also of great help if the boundaries of chunks are visible as lines or different colors while texturing.

Best Regards,

End-User

[Dmitry Semyonov]

Hello End-User,

Do you mean the enable/disable commands that control whether the corresponding chunks are used during chunk alignment/merging process?

The boundary display option you have proposed seems to be more difficult to implement, as the merged model is a separate mesh and information about the boundaries of individual chunks is lost after merging.

With best regards,
Dmitry Semyonov
AgiSoft LLC

[End-User]

Hello Dmitry,

Thanks for your  reply.

What I meant was not for the merged mesh.

It will be great to enable or disable certain chunks in the aligned view. That applies also to visualise the  boundaries of the chunks in the same view.

Best Regards,

End_User

[Dmitry Semyonov]

Hello End-User,

Thanks for the explanation. That makes sense.

We should check what can be done in this regard.

Dmitry