Forum

Author Topic: Simple orthophoto of the mesh  (Read 1900 times)

lins

  • Newbie
  • *
  • Posts: 13
    • View Profile
Simple orthophoto of the mesh
« on: October 27, 2017, 04:43:05 PM »
Hi everyone,

I just don't see where I can do a simple vertical georeferenced orthophoto, not an orthomosaic, of the mesh. Sometimes, the coloured mesh is enough and better than the orthomosaic but I don't find where to produce pictures of it.

Can you help me ?

Thanks

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 13913
    • View Profile
Re: Simple orthophoto of the mesh
« Reply #1 on: October 27, 2017, 04:50:17 PM »
Hello lins,

You can do that by switching the Model view mode to orthographic projection and then using Capture View option (from the Model view context menu).
Best regards,
Alexey Pasumansky,
Agisoft LLC

lins

  • Newbie
  • *
  • Posts: 13
    • View Profile
Re: Simple orthophoto of the mesh
« Reply #2 on: October 27, 2017, 04:59:15 PM »
Thanks,

I found the orthographic view but not the Capture View option in the software. I have the 1.3.2 version. Can you show with a screen view, where this option is? It seems that I am blind...

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 13913
    • View Profile
Re: Simple orthophoto of the mesh
« Reply #3 on: October 27, 2017, 05:04:25 PM »
Right-click anywhere in the Model view:
Best regards,
Alexey Pasumansky,
Agisoft LLC

lins

  • Newbie
  • *
  • Posts: 13
    • View Profile
Re: Simple orthophoto of the mesh
« Reply #4 on: October 27, 2017, 05:04:57 PM »
I found it ! Right click on the model screen !

But we can't produce a picture of the model with a joint .jgw file ? To put it in QGIS then.