Forum

Author Topic: smooth mesh in certain areas  (Read 3511 times)

davidsumner

  • Newbie
  • *
  • Posts: 47
    • View Profile
smooth mesh in certain areas
« on: February 07, 2017, 08:40:58 PM »
Is it possible to smooth or decimate a mesh in a prescribed polygonal region?

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14965
    • View Profile
Re: smooth mesh in certain areas
« Reply #1 on: February 08, 2017, 12:01:00 PM »
Hello davidsumner,

Not possible at the moment. But I we have such request in our list already.
Best regards,
Alexey Pasumansky,
Agisoft LLC

Stunnline

  • Newbie
  • *
  • Posts: 10
    • View Profile
Re: smooth mesh in certain areas
« Reply #2 on: December 13, 2017, 12:15:05 PM »
Hey! Is the function mentioned above available now?

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14965
    • View Profile
Re: smooth mesh in certain areas
« Reply #3 on: December 13, 2017, 02:27:13 PM »
Hello Stunnline,

Not available yet, but may be included in 1.4.0 final release.
Best regards,
Alexey Pasumansky,
Agisoft LLC

Stunnline

  • Newbie
  • *
  • Posts: 10
    • View Profile
Re: smooth mesh in certain areas
« Reply #4 on: December 13, 2017, 05:32:12 PM »
Ok, so it's not availaible in the pre-release, right?

Can you give me a rough date, when release 1.4.0 is going to start? :)

Erik Holmlund

  • Newbie
  • *
  • Posts: 37
    • View Profile
Re: smooth mesh in certain areas
« Reply #5 on: December 14, 2017, 05:12:37 PM »
Stunnline, the free software MeshLab supports both decimation and smoothing of selected faces. The selection process is in my experience a bit clunky however.

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14965
    • View Profile
Re: smooth mesh in certain areas
« Reply #6 on: December 14, 2017, 05:59:48 PM »
Hello Stunnline,

Not available in the current pre-release.

I think that release will be in the end of December - beginning of January.
Best regards,
Alexey Pasumansky,
Agisoft LLC

Stunnline

  • Newbie
  • *
  • Posts: 10
    • View Profile
Re: smooth mesh in certain areas
« Reply #7 on: December 14, 2017, 06:15:53 PM »
Ok, tank you both!