Features
Support
Community
Downloads
Buy
About
Forum
Home
Search
Login
Register
Agisoft Metashape
»
Agisoft Metashape
»
General
»
cancelling batch process
« previous
next »
Print
Pages: [
1
]
Author
Topic: cancelling batch process (Read 1982 times)
weissspice
Newbie
Posts: 15
cancelling batch process
«
on:
December 21, 2017, 09:39:22 PM »
Hi all,
I made the mistake of not selecting "save after each step" in a batch processing run, and now I'm wondering if I click cancel, whether I'll lose all the processing that has completed to this point. Running Pro. Thanks.
-c
Logged
Alexey Pasumansky
Agisoft Technical Support
Hero Member
Posts: 14853
Re: cancelling batch process
«
Reply #1 on:
December 21, 2017, 09:55:00 PM »
Hello weissspice,
I think that you will loose only the current stage results, whereas all the previous competed stages would be unaffected, so you should be able to save the project result at the current step.
Logged
Best regards,
Alexey Pasumansky,
Agisoft LLC
weissspice
Newbie
Posts: 15
Re: cancelling batch process
«
Reply #2 on:
December 21, 2017, 10:16:51 PM »
Oh thank goodness. I did a quick test run on a small chunk, and indeed, the data for the completed steps were retained.
Thanks again!
-c
Logged
selimerguden
Newbie
Posts: 21
Re: cancelling batch process
«
Reply #3 on:
December 21, 2017, 10:19:50 PM »
Hey Weissspice,
As Alexey mentioned you would only lose the current step. This happened to me multiple times and I haven't lost the entire project. Once you cancel it however make sure you save it instantly because if you don't and close your project you will lose it all.
Logged
Print
Pages: [
1
]
« previous
next »
Agisoft Metashape
»
Agisoft Metashape
»
General
»
cancelling batch process
Features
Support
Community
Downloads
Buy
About
Features
Support
Community
Downloads
Buy
About
Metashape presentation
(PDF, 5 Mb)