Forum

Author Topic: Mesh cut off  (Read 1420 times)

lfatica

  • Newbie
  • *
  • Posts: 1
    • View Profile
Mesh cut off
« on: January 29, 2018, 05:44:52 PM »
Hi all,
I'm having difficulty with a corner of my model being cut off when I create a mesh. It is always the same corner, and the cutoff line is a straight, clean edge. Everything looks fine in the dense cloud--the disappearing corner is there. It's only when I create the mesh that it goes away.
Has this happened to anyone else? Has anyone found a solution?
Many thanks,
Lawrence

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14813
    • View Profile
Re: Mesh cut off
« Reply #1 on: January 29, 2018, 06:47:48 PM »
Hello Lawrence,

Maybe you can post the screenshots for the dense cloud and mesh view modes, so that the bounding box is visible?
Best regards,
Alexey Pasumansky,
Agisoft LLC