Forum

Author Topic: 1.4.1 Mesh stage ignoring edited dense cloud  (Read 2635 times)

jkelly206

  • Newbie
  • *
  • Posts: 2
    • View Profile
1.4.1 Mesh stage ignoring edited dense cloud
« on: March 28, 2018, 03:40:20 PM »
Hi,

I'm getting a bug where the meshing stage will mesh only the original dense cloud and ignore any changes made. The only points that get ignored are ones outside of the bounding box. I've repeated this a few times now.

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14943
    • View Profile
Re: 1.4.1 Mesh stage ignoring edited dense cloud
« Reply #1 on: March 28, 2018, 04:02:15 PM »
Hello jkelly206,

Can you please post a couple of screenshots: edited dense cloud, mesh reconstruction parameters, mesh reconstruction results?
Best regards,
Alexey Pasumansky,
Agisoft LLC

jkelly206

  • Newbie
  • *
  • Posts: 2
    • View Profile
Re: 1.4.1 Mesh stage ignoring edited dense cloud
« Reply #2 on: March 29, 2018, 11:17:09 AM »
Hi,

Here are the images you requested:


Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14943
    • View Profile
Re: 1.4.1 Mesh stage ignoring edited dense cloud
« Reply #3 on: March 29, 2018, 11:47:54 AM »
Hello jkelly206,

According to the screenshots you are building mesh using new (experimental) method based on the depth maps, so changes applied to the dense cloud are ignored.

If you wish to build mesh basing on the dense cloud, then switch off experimental mesh reconstruction feature in the Advanced Preferences tab.
Best regards,
Alexey Pasumansky,
Agisoft LLC