Forum

Author Topic: exort ortho_image using point cloud  (Read 4439 times)

Bruno Andrieu

  • Jr. Member
  • **
  • Posts: 51
    • View Profile
exort ortho_image using point cloud
« on: April 13, 2014, 02:02:21 PM »
Hello

Is it possible to export ortho images computed from the point cloud instead of the mesh ?


building high resolution  textures  usually fails  with my computer and  images from vH points cloud would be sufficient.

Bruno

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 15168
    • View Profile
Re: exort ortho_image using point cloud
« Reply #1 on: April 22, 2014, 11:10:44 PM »
Hello Bruno,

You can build mesh based on sparse cloud and it will take a few seconds and will not require much time and resources.
Also please note that texure generation is not required for orthophoto export.
Best regards,
Alexey Pasumansky,
Agisoft LLC

Bruno Andrieu

  • Jr. Member
  • **
  • Posts: 51
    • View Profile
Re: exort ortho_image using point cloud
« Reply #2 on: May 17, 2014, 10:58:42 AM »
Thanks Alexey

If I build mesh from sparse cloud then I have a mesh with a low resolution, and I cannot really use it.

It would be usefull for me  to understand which data are used to build orthophotos: can you explain ?

It would be useful for me to generate high resolutions 2D views of my models. At the moment I use copies of my screen which displays the point cloud, but this gives not full resolution on the whole model. Can you explain how I should proceed ?

Bruno