Forum

Author Topic: Shortkey and default export options  (Read 1049 times)

toxicmag

  • Jr. Member
  • **
  • Posts: 87
    • View Profile
Shortkey and default export options
« on: June 22, 2018, 10:56:08 AM »
Dear Developer-Team,

a time consuming and error-susceptible way is the export of final products.

If there are many chunks and everything is finally processed you have to click and click and click over and over again (i.e. for exporting orthomosaics from each chunk).

#1
A Shortkey or combination to reach the most common menufunctions would be good.

#2
Setting default export params would be good, too. It's awkward to enter the compression ratio and format every single time again.

Thanks so far.

Alex
#multirotor #VTOL #Trinity #Quantum-Systems #a6000 #a7R #RedEdge #ALTUM #RX1II