Flattening Water Bodies

[sarko]

Hello,


I work with Photoscan with aerial data and have run into a small problem.  As is often the case, water bodies tend to show a lot of distortion due to problems correlating on these surfaces.  Is there a way in Photoscan to flatten these bodies in the model?  I would like to define an area and either give it a height value or just have Photoscan flatten from one side to the other.  Any thoughts?

Thanks,
Scott

[Alexey Pasumansky]

Hello Scott,

I think it is possible to cut water areas up to the coast and then use "Fill Holes" command.