Features
Support
Community
Downloads
Buy
About
Forum
Home
Search
Login
Register
Agisoft Metashape
»
Agisoft Metashape
»
General
»
Disable automatic hole filling when building mesh?
« previous
next »
Print
Pages: [
1
]
Author
Topic: Disable automatic hole filling when building mesh? (Read 1405 times)
FredR
Guest
Disable automatic hole filling when building mesh?
«
on:
August 14, 2018, 05:28:45 PM »
Hello,
PS automatically fills holes, even large ones, when building mesh from dense cloud.
I don't see a parameter in build mesh to control hole filling with Arbitrary (3D) surface type.
Any help would be appreciate.
Thank you!
Logged
FredR
Guest
Re: Disable automatic hole filling when building mesh?
«
Reply #1 on:
August 15, 2018, 04:19:08 PM »
Anyone can help on this issue ?
Logged
Alexey Pasumansky
Agisoft Technical Support
Hero Member
Posts: 14813
Re: Disable automatic hole filling when building mesh?
«
Reply #2 on:
August 16, 2018, 06:56:09 PM »
Hello FredR,
For the experimental (visibility consistent) mesh generation operation it is not possible to disable hole filling.
Also hole filling cannot be disabled when mesh is generated from the sparse point cloud.
Logged
Best regards,
Alexey Pasumansky,
Agisoft LLC
Print
Pages: [
1
]
« previous
next »
Agisoft Metashape
»
Agisoft Metashape
»
General
»
Disable automatic hole filling when building mesh?
Features
Support
Community
Downloads
Buy
About
Features
Support
Community
Downloads
Buy
About
Metashape presentation
(PDF, 5 Mb)