Forum

Author Topic: Disable automatic hole filling when building mesh?  (Read 982 times)

FredR

  • Guest
Disable automatic hole filling when building mesh?
« on: August 14, 2018, 05:28:45 PM »
Hello,

PS automatically fills holes, even large ones, when building mesh from dense cloud.
I don't see a parameter in build mesh to control hole filling with Arbitrary (3D) surface type.

Any help would be appreciate.

Thank you!

FredR

  • Guest
Re: Disable automatic hole filling when building mesh?
« Reply #1 on: August 15, 2018, 04:19:08 PM »
Anyone can help on this issue ?

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 13335
    • View Profile
Re: Disable automatic hole filling when building mesh?
« Reply #2 on: August 16, 2018, 06:56:09 PM »
Hello FredR,

For the experimental (visibility consistent) mesh generation operation it is not possible to disable hole filling.

Also hole filling cannot be disabled when mesh is generated from the sparse point cloud.
Best regards,
Alexey Pasumansky,
Agisoft LLC