Forum

Author Topic: Limit box for viewing / classification  (Read 3546 times)

kgrover

  • Newbie
  • *
  • Posts: 40
    • View Profile
Limit box for viewing / classification
« on: October 12, 2018, 08:26:58 PM »
It would be great to have the ability to set a limit box in the 3D view to better work with the dense cloud. It can be hard to properly select / view points that you need to clean, classify, etc. in the view as all the points are visible.

But with a limit box that you can resize move, etc. on the fly to clip the dense cloud would be ideal. Then it would allow for easier point selection of noisy points, or when manually classifying trees, buildings, etc.

Kevin

SAV

  • Hero Member
  • *****
  • Posts: 710
    • View Profile
Re: Limit box for viewing / classification
« Reply #1 on: November 10, 2018, 01:14:01 PM »
+1

Or a slicing option where you can just work on a freely chosen slice of the point cloud or mesh
Slice properties are position, orientation and width, e.g., only show a 50m slice that is vertical (cross section) and running East - West

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14813
    • View Profile
Re: Limit box for viewing / classification
« Reply #2 on: November 10, 2018, 06:32:17 PM »
Hello Kevin,

Please check if the option from Tools Menu -> Dense Cloud -> Filter by Selection does suffice your needs. It hides all but currently selected points in the Model view. After you finished editing the filtered part you can Reset Filter to see the complete cloud with the edits applied.
Best regards,
Alexey Pasumansky,
Agisoft LLC

jefferson de faria

  • Newbie
  • *
  • Posts: 3
    • View Profile
Re: Limit box for viewing / classification
« Reply #3 on: November 19, 2018, 06:56:52 PM »
this feature was added in which version?


Hello Kevin,

Please check if the option from Tools Menu -> Dense Cloud -> Filter by Selection does suffice your needs. It hides all but currently selected points in the Model view. After you finished editing the filtered part you can Reset Filter to see the complete cloud with the edits applied.

Alexey Pasumansky

  • Agisoft Technical Support
  • Hero Member
  • *****
  • Posts: 14813
    • View Profile
Re: Limit box for viewing / classification
« Reply #4 on: November 19, 2018, 07:20:40 PM »
Hello Jefferson,

It is available in the latest release version (1.4.4).
Best regards,
Alexey Pasumansky,
Agisoft LLC

kgrover

  • Newbie
  • *
  • Posts: 40
    • View Profile
Re: Limit box for viewing / classification
« Reply #5 on: December 20, 2018, 10:56:55 PM »
I have been using that tool, which is good, but the problem is that you have to keep resetting the filter when you need to select a new area of points. It works (and a good first step), but kind of a pain with larger edits.

Ideally a limit box (similar to many other point cloud tools), pretty much like region box in Agisoft, but only that only controls the current view of points. So you can dynamically edit the limit box as needed (move, resize, etc.), instead of selecting a new area, filter by selection, the reset, and keep doing over again.